A perfectly proportioned blend of high quality type ‘S’ Masonry Cement clean and sharp brick sand.
Uses
Use as a Masonry binder for brick, block and stone and as a Parging Mix.
Suggested Uses Are:
Laying Brick – Setting Block – Patching – Tuck Pointing – Barbeques – Parging – Stuccoing – Stone Work – Chimney Repair
Features and Technical Data
- Pre-blended and ready to use – Just add water.
- Exceeds ASTM C-270 for Type ‘S’ Mortar when mixed and installed as directed.
- Backed by Independent Quality Control Tests.
- IN 66 LB (30 KG) BAGS 56 PER SKID
Coverage
Each 66 lb bag will lay approximately 55 standard bricks or 12 standard blocks with a 3/8 inch mortar joint.
Preparation
All surfaces should be clean and free of oil, gas, paint, grease, etc. before applying Mortar Mix.
Directions
Pour required amount of Mortar Mix into a clean wheelbarrow, mortar-box or similar container. Form a crater in the centre of the dry mix and pour in clear water while mixing with shovel or hoe. Water content should be about 1 quart for every 20 pounds of dry Mortar Mix. Mix to the consistency of a heavy batter.
For best results
Always use clean equipment, tools and water. A mechanical paddle-type mixer is recommended. Use a measurable container so the exact amounts are used for each batch. Avoid working in extreme heat. Use only when the temperature is 40ºF and rising. In cooler weather, use warm (not hot) water. Mix for 6 to 8 minutes. Thoroughly dampen the brick, block or repair area before applying the new Mortar to prevent a premature drying of the new material. Keep the new Mortar damp for at least 3 days by an occasional fine spraying of water.